ISO INTERNATIONAL STANDARD 7176-11 Secondedition 2012-12-01 Wheelchairs - Part 11: Test dummies Fauteuils roulants- Partie 11: Mannequins d'essai Reference number ISO 7176-11:2012(E) LSO IS02012 py IHS under lic or networking permitted without license from IHS Not for Resale IS0 7176-11:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the addressbeloworIso'smemberbodyinthecountryoftherequester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel.+41227490111 Fax +41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2012 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 7176-11:2012(E) Contents Page Foreword ..iv Introduction. ...vi 1 Scope. 2 Normative references ..1 3 Terms and definitions 4 Symbols and abbreviated terms ..3 5 Test equipment. ..3 6 Materials. ..6 6.1 General .6 6.2 Rigid spacers .6 6.3 Foam cushions. .6 7 Specifications .6 7.1 General. .6 7.2 Location of pivots. .7 7.3 Loading pads. ..8 7.4 Adjustment of location of overall centre of mass .12 7.5 Masses of segments. 12 7.6 Locations of centres of mass .13 7.7 Test dummies intended for use in a standing position .14 7.8 Examples of test dummy construction. .15 Annex A (normative) Measurement of location of overall centre of mass ..17 Annex B (informative) Nominal location of overall centre of mass ..23 Annex C (informative) Nominal masses and recommended CoM locations of segments ..24 AnnexD (informative) Views of exampletest dummies. .26 Bibliography .29 iii Stal se with ISt thout license from IHS Not for Resale