TECHNICAL ISO/TS SPECIFICATION 15011-6 First edition 2012-07-15 Health and safety in welding and allied processes Laboratory method for sampling fume and gases - Part 6: Procedure for quantitative determination of fume and gases from resistance spot welding Hygiene et sécurite en soudage et techniques connexes - Methode de laboratoire d'échantillonnage des fumees et des gaz Partie 6: Procedure pour la détermination quantitative des fumées et desgazgeneresparlesoudageparresistanceparpoints Reference number ISO/TS 15011-6:2012(E) @ ISO 2012 ISO/TS 15011-6:2012(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or isO's memberbody inthe country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. ;+ 41 22 749 01 11 Fax+41 22 749 09 47 E-mail [email protected] Web:www.iso.org Published in Switzerland @ISO 2012-All rights reserved itted without license from IHS Not for Resale ISO/TS 15011-6:2012(E) Contents Page Foreword Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Principle 5 Apparatus 6 Procedure... 6.1 Preparation of test pieces.. 6.2 Set up of welding equipment 6.3 Selection of welding parameters 6.4 Fume emission rate. 6.5 Emission rate of gases 7 Calculation method .. 7.1 Emission rate of dust. 7.2 Emission rate of gases 8 Documentation 9 Test report.... Annex A (informative) Examples of designs of fume box... Annex B (informative) Example of a welding chamber for determination of the emission rate of gases.... .13 Annex C (normative) Welding parameters .16 Annex D (informative) Example of test report... .17 Bibliography. ..19 Copyright International Organization for Standardizalion'ghts reserved ii from IHS