ISO INTERNATIONAL STANDARD 10071-1 Second edition 2008-11-15 Tools for pressing Ball-lock punches - Part 1: Ball-lock punches for light duty Outillage de presse- Poincons a bille- Partie 1: Poincons a bille pour toles minces Reference number ISO 10071-1:2008(E) @ ISO 2008 py IHS under lic ted without license from IHS Not for Resale ISO 10071-1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT ?ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel.:+ 41227490111 Faxi + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2008 - All rights reserved edwithoutlicense from IHS Not for Resale ISO 10071-1:2008(E) Contents Page Foreword iv 1 Scope 1 2 Normative references 3 Terms anddefinitions... 4 Dimensions... 4.1 Basic dimensions Ball in locking position. 4.2 Perforating punches ..... 4.3 4.4 Punches with ejector. 5 Material and hardness. 11 9 Designation .11 Bibliography ..12 Copyrght International Organizaion forstandardizalon'ghts reserved ii dby IHS under se with IS ed without license from IHS Not for Resale