ISO INTERNATIONAL STANDARD 16653-1 First edition 2008-06-01 Mobile elevating work platforms : Design, calculations, safety requirements and test methods relative to special features - Part 1: MEWPs with retractable guardrail systems Plates-formes élevatrices mobiles de personnel Conception, calculs, exigences de sécurite et méthodes d'essai concernant les caractéristiques spéciales - Partie 1: PEMP avec systeme de garde-corps rétractable Reference number ISO 16653-1:2008(E) @ ISO 2008 HS under I without license from IHS Not for Resale ISO 16653-1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2008 - All rights reserved I without license from IHS Not for Resale ISO 16653-1:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 16653-1 was prepared by Technical Committee ISO/TC 214, Elevating work platforms ISO 16653 consists of the following parts, under the general title Mobile elevating work platforms Design calculations, safety requirements and test methods relative to special features: 一 Part 1: MEWPs with retractable guardrail systems Part 2: MEWPs with non-conductive (insulating) components MEWPs for orchard operations are to form the subject of a future part 3 ili