ISO INTERNATIONAL STANDARD 11662-1 Firstedition 1995-06-01 ANSI Internat Doc Sec Mobile cranes Experimental determination of crane performance -- Part 1: Tipping loads and radi Grues mobiles Determination expérimentale des performances des grues- Partie 1: Charges de basculement et portées ISO Referencenumber ISO 11662-1:1995(E) right International Organization for Standardizatior Provided by IHS under license with ISC Not for Resale ISO 11662-1:1995(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing international Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which atechnical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, aiso take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. Internationai Standard ISO 11662-1 was prepared by Technical Committee iSO/TC 96, Cranes, Subcommittee SC 6, Mobile cranes. IsO 11662 consists of the following parts, under the general title Mobile cranes -- Experimental determination of crane performance : Part 1: Tipping loads and radi Part 2: Structural characteristics Part 3: Dynamic characteristics Annex A of this part of ISO 11662 is for information only. ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced orutilized in any form or by anymeans,electronic or mechanical,including photocopyingand microfilm, without permission in writing from the publisher. International Organization for Standardization Casepostale56CH-1211Geneve20Switzerland Printed in Switzerland No reproduction or networking permited without license from IHS Not for Resale @ISO ISO 11662-1:1995(E) Introduction ISO 11662 specifies test methods to be used to verify the design of a tests carried out on the prototype of a new model. Based on the test results, the load chart of the crane shall be modified where necessary to comply with the requirements of the International Standard. i e with ISO No reproduction or networking permited without license from IHS Not for Resale