ISO INTERNATIONAL STANDARD 4950-2 Second edition 1995-08-15 AMENDMENT1 2003-12-01 High yield strength flat steel products Part 2: Products supplied in the normalized or controlled rolled condition AMENDMENT 1 Produits plats en acier a haute limite d'elasticite- Partie 2: Produits livrés a I'etat normalise ou de laminage controle AMENDEMENT1 Reference number ISO 4950-2:1995/Amd.1:2003(E) [So @ ISO 2003 No reproduction or networking permited without license from IHS Not for Resale SO4950-2:1995/Amd.1:2003(E) PDFdisclaimer shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer perfoming the editing. In accepts no liability in this area Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by Iso member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ? ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any fom or by any means, iSO's memberbody in thecountry oftherequester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax+41227490947 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @Iso2003-All rights reserved ndardization Reproduced by IHS under license with ISO Not for Resale ISO4950-2:1995/Amd.1:2003(E) Foreword non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights.TSOshallnotbeheldresponsibleforidentifyinganyorallsuchpatentrights. Amendment 1 to ISO 4950-2:1995 was prepared by Technical Committee ISO/TC 17, Steel, Subcommittee Sc3, Steelsforstructuralpurposes. andardizationrightsreserved i