ISO INTERNATIONAL STANDARD 8092-3 First edition 1996-02-01 Road vehicles Connections for on-board electrical wiring harnesses Part 3: Tabs for multi-pole connections Dimensions and specific requirements Véhicules routiers Connexions pour faisceaux de cablage électrique embarques Partie 3: Languettes pour raccordements multipolaires - Dimensions et exigencesparticulieres ISO Reference number ISO 8092-3:1996(E) 1S08092-3:1996(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (lso member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (lEC) on all matters of electrotechnical standardization. circulated to the member bodies for voting. Publication as an International Standard requires approvai by at least 75 % of the member bodies casting a vote International Standard ISO 8092-3 was prepared by Technical Committee ISO/TC 22, 1 Road vehicles, Subcommittee SC 3, Electrical and electronic equipment. IsO 8092 consists of the following parts, under the general titie Road ve- hiclesConnectionsforon-boardelectricalwiringharnesses: Part 1: Tabs for single-pole connections -- Dimensions and specific requirements - Part 2: Definitions, test methods and general performance require- ments Part3:Tabs formulti-pole connections sDimensionsandspecific requirements Part 4: Pins for single- and multi-pole connections -- L Dimensions and specific requirements ISO 1996 or utilized in any form or by any means, electronic or mechanical, including photocopying and International Organization for Standardization Case Postale 56 . CH-1211 Geneve 20: Switzerland Printed in Switzerland ii Not for Resale INTERNATIONAL STANDARD ISO ISO 8092-3:1996(E) Road vehicles Connections for on-board electrical wiring harnesses . Part 3: Tabs for multi-pole connections Dimensions and specific requirements 1 Scope Definitions This part of IS0 8092 specifies dimensions for the For the purposes of this part of IsO 8092, the defi- tabs of multi-pole connections and specific require nitions given in ISO 8092-2 apply. ments, for on-board electrical wiring harnesses of road vehicles.It applies to connections designed to 4 Dimensions be disconnected after mounting in the vehicle for the purposes of repair and/or maintenance only. Tabs for multi-pole connectors shall conform to the dimensions given in table 1 and figure 1. Details not specified are left to the manufacturer's choice. 2 Normative reference 5 Specific performance requirements The following standard contains provisions which, Multi-pole connections shall be in conformity with the through reference in this text, constitute provisions general performance requirements of ISO 8092-2, and of this part of ISO 8092. At the time of publication, the shall meet the following specific requirements. edition indicated was valid. All standards are subject to revision, and parties to agreements based on this 5.1 Design requirements part of 1sO 8092 are encouraged to investigate the possibility of applying the most recent edition of the If tabs are stamped or stamped and formed, the standardindicatedbelow.MembersofIECandISO usable contact area shall be specified and care shall maintain registers of currently valid International be taken to assure that gaps, seams and rounded Standards. edges do not affect the contact performance. Is0 8092-2:1996, Road vehicles --- Connections for 5.2 Connection resistance on-boardelectrica/wiringharnesses Part2:Defi nitions, test methods and general performance re- The connection resistance of multi-pole connections. quirements. t