ISO INTERNATIONAL STANDARD 8351-1 First edition 1994-07-15 Packaging --- Method of specification for sacks - Part 1: Paper sacks Emballages Methode de spécification des sacs Partie1:Sacsenpapier so Reference number ISO8351-1:1994(E) No reproduction or networking permitted without license from IHS Not for Resale ISO 8351-1:1994(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (lEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 8351-1 was prepared by Technical Committee ISO/TC 122, Packaging, Subcommittee SC 2, Sacks. IsO 8351 consists of the following parts, under the general title Packaging Method of specificationfor sacks: --- Part 1: Paper sacks Part 2: Sacks made from thermoplastic flexible film ISO 1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland ii n for Standardizi Not fr Resale INTERNATIONAL STANDARD ISO ISO 8351-1:1994(E) Packaging -- Method of specification for sacks - Part 1: Paper sacks 1 Scope where relevant, mutually agree to include them in the ordering specifications at an appropriate level. This part of ISO 8351 provides a checklist for the characteristics of paper sacks to be specified when The format of the ordering specification shall be agreed upon between the customer and the manu- ordering. These ordering specifications cover the de- scription of the sack and do not deal with quantitative facturer. performance requirements. This part of ISO 8351 is primarily intended for application to the types of paper 3.2 Description sacks specified in ISO 6590-1. 3.2.1 Sack type Normative references 3.2.1.1 Open-mouth The following standards contain provisions which, through reference in this text, constitute provisions - sewn flat: of this part of ISO 8351. At the time of publication, the editions indicated were valid. All standards are subject sewn gusseted; to revision, and parties to agreements based on this part of IsO 8351 are encouraged to investigate the pasted flat hexagonai-bottom; possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO - pasted flat turn-over-bottom; maintain registers of currently valid International Standards pasted gusseted rectangular-bottom; Iso 6590-1:1983,Packaging—Sacks- Vocabulary pasted gusseted turn-over-bottom; and types -- Part 1: Paper sacks. other not specified above. IsO6591-1:1984,Packaging—Sacks-Description and method of measurement --- Part 1: Empty paper 3.2.1.2 Valved (closed-mouth) sacks. -sewnflat; 3 Method of specification sewn gusseted; 3.1 General - pasted flat hexagonal-ends; When drawing up the specifications of a paper sack pasted gusseted rectangular-ends: for ordering purposes, customer and manufacturer shall consider each item in the following lists and, --- other not specified above. Copyright No reproduction or networking permitted without license from IHS Not for Resale