ISO INTERNATIONAL STANDARD 8489-4 First edition 1995-12-15 Textile machinery and accessories - Cones for cross winding Part 4: Dimensions, tolerances and designation of cones with half angle 4° 20' for winding for dyeing purposes Materiel pour I'industrie textile - Cones pour bobinage croisé Partie 4: Dimensions, tolerances et désignation des cones avec demi-angle au sommet de 4° 20' pour bobinage pour la teinture ISO Referencenumber ISO 8489-4:1995(E) No reproductic ISO8489-4:1995(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental andnon-governmental,inliaisonwithIsO,alsotakepartinthework.Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO/TC 72, Textile machinery and allied machinery and accessories, Sub- ture. This first edition of ISO 8489-4 cancels and replaces ISO 324:1978, which has been technically revised. IsO 8489 consists of the following parts, under the general title Textile machinery and accessories - Cones for cross winding: Part 1:Recommended main dimensions angle 3 degrees 30" angle 4 degrees 20 angle 4 degrees 20' for winding for dyeing purposes Part 5: Dimensions, tolerances and designation of cones with half angle 5 degrees 57 ISO 1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland Not for Resale INTERNATIONAL STANDARD ISO ISO 8489-4:1995(E) Textile machinery and accessories -- Cones for cross winding Part 4: Dimensions, tolerances and designation of cones with half angle 4° 2o' for winding for dyeing purposes 1 Scope This part of IsO 8489 specifies the main dimensions, tolerances and designation of cones for cross winding for dyeing purposes with a half angle of cone 4° 20'. Furthermore, directives are given for the characteristics of cones and for the control of the diameters and lengths of the cone. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this part of IsO 8489. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of isO 8489 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 286-1:1988, ISO system of limits and fits - Part 1: Bases of tolerances, deviations and fits. dimensions. Copyright Interna Standardizatio Noreproductionornetworkingpermited without licensefromHS Not for Resale