ISO INTERNATIONAL STANDARD 6038 Second edition 1993-04-15 Cinematography -- Splices for use on 70 mm, 65 mm, 35 mm and 16 mm motion-picture films Dimensions and locations Cinématographie - Raccords sur films cinématographiques 70 mm, 65 mm, 35 mm et 16 mm — Dimensions et emplacements Referencenumber ISO 6038:1993(E) No reproduction or networking permited without license from IHS Not for Resale ISO 6038:1993(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 6038 was prepared by Technical Committee ISO/TC 36, Cinematography. This second edition cancels and replaces the first edition (ISO 6038:1985), of which it constitutes a technical revision. Annex A of this International Standard is for information only. ISO 1993 All rights reserved. No part of this publication may be reproduced or utilized in any form or by, any means. electronic or mechanical, including photocopying and microfilm, without per- mission in writing from the publisher. International Organization for Standardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland Copyright Int No reproduction or networking permitted without license from IHS Not for Resale ISO6038:1993(E) INTERNATIONALSTANDARD Cinematography Splices for use on 70 mm, 65 mm, 35 mm and 16 mm motion-picture films Dimensions and locations Scope Dimensions 1.1 This International Standard specifies the dimen- 2.1 The dimensions specified in tables 1 to 5 apply sions and locations of transverse cemented or welded to motion-picture films which contain nominal overlap splices and butt splices on 70 mm, 65 mm, shrinkage up to 0,2 %, and recently made splices. 35 mm and 16 mm motion-picture films and prints with magnetic or photographic sound records. 2.2 The dimensions of cemented or welded overlap 1.2 The following types are specified: splices for 16 mm motion-picture films shall be as shown in figures 1, 2 and 5 and as given in tables 1 a) Type 1 -- Laboratory type, overlap splice intended and 5. for negatives and intermediate films, perforated short pitch; 2.3 The dimensions of butt splices shall be in ac- cordance with the dimensions B and E as specified in b) Type 2 _ Projection type, overlap splice intended tables 1 to 5. for prints with non-anamorphic type picture; c) Type 3 - Projection type, overlap splice intended 2.4The dimensions for 70 mm, 65 mm and 35 mm for prints with anamorphic type picture; motion-picture films shall be as shown in figures 3 to 5 and as given in tables 2 to 5. d) Type 4 - Projection type, overlap splice made with transparent adhesive tape and intended for 2.5 The film width at the splice shall not exceed prints; 70,05 mm (2,758 in) for 70 mm films; e) Type 5 — Projection type specialized uses, butt 65,05 mm (2,561 in) for 65 mmfilms; splice made with transparent tape and intended for 35,03 mm (1,379 in) for 35 mm films; prints. 16,00 mm (0,630 in) for 16 mm films. Not for Resale