ISO INTERNATIONAL STANDARD 6701 First edition 1991-01-15 Cycles --- External dimensions of spoke nipples Cycles -- Dimensions exterieures des ecrous de rayons Reference number ISO 6701:1991(E) Not for Resale ted without license from IHS ISO 6701:1991(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (iEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Inter- national Standard requires approva! by at least 75 % of the member bodies casting a vote. International Standard IsO 6701 was prepared by Technical Committee ISO/TC 149, Cycles. C ISO1991 Alt rights reserved. No part of thls publlcation may be reproduced or utilized in any form or by any means, electronlc or mechanical, including photocopying and microfiln, without permission in writing from the publisher. international Organization for Standardizatlon Case Postale 56: CH-1211 Geneve 20 · Switzerland Printed in Switzeriand ii Not for Resale ISO 6701:1991(E) INTERNATIONALSTANDARD Cycles -- External dimensions of spoke nipples Scope Designation 1 This International Standard specifies the external dimensions and tolerances of the spoke nipples of Any spoke nipple in conformity with the specifi- bicycles. It also specifies the designation. cations of this International Standard shall be des- ignated by the number of this International Standard, It applies to round or flat head spoke nipples. followed by the wire diameter, expressed in milli- metres. 2 Dimensions Example of designation: External dimensions of spoke nipples shall be those indicated in figure 1 and table 1. Nipple 1SO 6701 2 V-V 222222 Key: @d, = dlameter of body r+ =round head radus dk = dlameter of head I2 - thickness of head = Length of square - width of slot size of square = depth of stot Figure 1 Copyright International Organization for Standardization d without license from IHS Not for Resale