ISO INTERNATIONAL STANDARD 8283-1 First edition 1991-05-01 Plastics pipes and fittings -- Dimensions of sockets and spigots for discharge systems inside buildings Part 1: Unplasticized poly(vinyl chloride) (PVC-U) and chlorinated poly(vinyl chloride) (PVC-C) Tubes et raccords en matieres plastiques -- Dimensions des emboitures et des bouts males pour raccordement de tubes et raccords dans les systemes d'évacuation a I'interieur des batiments - Partie 1: Poly(chlorure de vinyle) non plastifie (PVC-U) et poly(chlorure de vinyle) chlore (PVC-C) Reference number ISO 8283-1:1991(E) Not for Resale ISO 8283-1:1991(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with IsO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission(lEC)onall mattersof electrotechnicalstandardization Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an inter- bodies casting a vote. International Standard 1sO 8283-1 was prepared by Technical Committee ISO/TC 138, Plastics pipes, fittings and valves for the transport of fluids. iso 8283 consists of the following parts, under the general title Plastics pipes and fittings Dimensions of sockets and spigots for discharge systems inside buildings: Part 1: Unplasticized poly(vinyl chloride) (PvC-U) and chlorinated poly(vinyl chloride) (PVC-C) --- Part 2: High-density polyethylene (PE-HD) -- Part 3: Polypropylene (Pp) ---Part4:Acrylonitrile/butadiene/styrene(ABs) Annexes A and B form an integral part of this part of IsO 8283. C ISO1991 Ali rights reserved. No part of this publlcation may be reproduced or utilized in any form or by any means, electronlc or mechanlcal, Including photocopying and microflim, without permlssion in writing from the publisher. international Organization for Standardization Case Postale 56: CH-1211 Geneve 20 · Swltzerland Printed In Switzerland i ematoganai Standardizato d without license from IHS Not for Resale ISO 8283-1:1991(E) Introduction The socket design appropriate for a particular application should be chosen according to the type of system and jointing techniques to be used. Various socket designs are specified in this part of iso 8283. They may be selected for use in accordance with the requirements of relevant national standards and codes of practice, which give information on the choice of the type of system and jointing techniques to be used. nited without license from IHS No reproductic Not for Resale