TSO NTERNATIONAL STANDARD 1072 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION MEKIYHAPOHA OPrAHW3ALW IO CTAHIAPTW3ALIWW.ORGANISATION INTERNATIONALE DE NORMALISATION Solid wood parquet -- General characteristics Parquet en bois massif -- Caracteristiques generales First edition - 1975-09-15 UDC 69.025.351.3.004.12 Ref. No. ISO 1072-1975 (E) SO 1072-1975 ( Descriptors : wood products, floor coverings, parquet strips, specifications, dimensions. Price based on 6 pages CopyrightInternational Oorganization for Standardization Not for Resale FOREWORD ISO (the Internationat Organization for Standardization) is a worldwide federation of national standards institutes (ISO Member Bodies). The work of developing International Standards is carried out through Iso Technical Committees. Every Member Body interested in a subject for which a Technical Committee has been set up has the right to be represented on that Committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. Draft International Standards adopted by the Technical Committees are circulated to the Member Bodies for approval before their acceptance as International Standards by the ISO Council. IS0 1072 was drawn up by Technical ( Internationa! Standard Committee September 1973. It has been approved by the Member Bodies of the following countries : Austria Germany Poland Bulgaria Hungary Romania Chile Ireland South Africa, Rep. of Czechoslovakia* Italy Thailand Egypt, Arab Rep. of Netherlands U.S.S.R. France New Zealand Yugoslavia with the exception of sub-clauses 4.1.2 and 4.1.3. The Member Bodies of the following countries expressed disapproval of the document on technical grounds : Australia Norway This International Standard cancels and replaces ISO Recommendation R 1072-1969, of which it constitutes a technical revision. @ International Organization for Standardization, 1975 Printed in Switzerland Not for Resale ed withoutlicense from IHS ISO 1072-1975 (E) INTERNATIONAL STANDARD Solid wood parquet - General characteristics 1 SCOPE AND FIELD OF APPLICATION The erds shall be perpendicular to the edges within a tolerance of 0,4 %. 1.1 This International Standard specifies . the manufacturing characteristics (cross-section, dimensions, 3.2 The face shall be smooth and the manufacturing faults permissible deviations, etc.), the inspection and delivery limited (see the relevant International Standards for the conditions and the marking of solid wood parquet strips classification of parquet strips of different wood species). with rectangular face of any species of wood. 3.3 Unless otherwise agreed, the strip edges and ends 1.2 The classification according to specific characteristics, should have the same profile. wood defects and possible exceptions is laid down, for the different species of wood, in the relevant International 3.4 The joining of the tongues and the grooves, in the case Standards. of strips with integrated tongue, shall be done without resistance and without excessive clearance. 2 REFERENCES 3.5 In the case of strips with detachable tongue, the ISO/R 2036, Marking of the different species of wood tongue shall enter the groove with a slight resistance and utilized in the manufacture of wood flooring -- Code of without clearance. symbols. ISO. , Wood parquet and raw parquet blocks - Terms 4 REQUIRED CHARACTERISTICS and definitions. 1) 4.1 Geometrical characteristics 3 MANUFACTURE The solid wood parquet strips are manufactured in three 3.1 The finished strips shall have the dimensions and the different profiles, called respectively : types P, (variants A profile specified in 4.1. and B), P2 and P3, having the dimensional characteristics The faces shall be flat. Contiguous faces and edges shall given for each of them in tables 1, 2, 3 and 4 and shown in form parallel sharp edges. figures 1, 2 and 3. 1) In preparation. Copyright International Organization for Standardization Not for Resale efrom IHS