(ISO 2964 nternational Standard miernat Doc Sect Aerospace - Tubing -- Outside diameters and thicknesses Metric dimensions Aeronautique et espace --- Tubes -- Diametres extérieurs et épaisseurs -- Dimensions metriques Second edition - 1985-04-01 UDC 629.13.01-462 Ref. No. 1SO 2964-1985 (E) ISO 2964-1985 (E) Descriptors : aircraft industry, aircraft equipment, pipes (tubes), metal tubes, dimensions Price based on 2 pages CopyrightInternational Organization for Standardization d without license from IHS Not forResale Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (1sO member bodies). The work of preparing nternational Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISO Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 2964 was prepared by Technical Committee ISO/TC 20, Aircraft and space vehicles. Is0 2964 was first published in 1974 This second edition cancels and replaces the first edition, of which it constitutes a technical revision. @ International Organization for Standardization, 1985 Printed in Switzerland Copyright International Organization for Standardization d without licensefrom IHS Not for Resale ISO 2964-1985 (E) INTERNATIONAL STANDARD Aerospace -- Tubing - Outside diameters and thicknesses - Metric dimensions 1Scope and fieid of application This International Standard specifies the outside diameters and thicknesses of tubes, for all metallic materials, to be selected for al! uses in aircraft structural and system design. 2 Dimensions Tolerances 3 The tolerances shall be specified in the relevant standards appropriate to the material and intended application Not for Resale