DRAFTINTERNATIONALSTANDARD IS0/DIS 24089 ISO/TC22/SC32 Secretariat: JISC Voting begins on: Voting terminates on: 2022-01-11 2022-04-05 Road vehicles s Software update engineering Vehiculesroutiers-Ingenieriedemisea jourdulogiciel ICS:43.040.15 THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENTAND APPROVAL.ITIS THEREFORE SUBJECT TO CHANGE AND MAY This document is circulated as receivedfromthe committee secretariat. NOT BE REFERRED TO AS AN INTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STANDARDS TO WHICH REFERENCE MAY MADE IN Reference number NATIONAL REGULATIONS. IS0/DIS24089:2022(E) RECIPIENTS OF THIS DRAFT ARE INVITED ISO SUBMIT, WITHTHEIRCOMMENTS NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. ISO2022 IS0/DIS24089:2022(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2022 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced orutilized otherwise in anyform orby any means,electronicor mechanical,including photocopying,orposting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or ISO's member body in the country of the requester. ISo copyrightoffice CP 40i:Ch.de Blandonnet 8 CH-1214Vernier,Geneva Phone: +4122 749 0111 Email: [email protected] Website:www.iso.org Published in Switzerland i IS02022-Allrightsreserved IS0/DIS24089:2022(E) 14 Contents 15 16 Foreword iv 17 Introduction. 18 Scope. 19 2 Normativereferences 20 3 Terms and definitions. 21 3.1 Generalterminology... 22 3.2 Terminology for the software update operation.... 23 4 Organization level software update requirements.. 24 5 25 4.2 General.... 6 26 4.3Requirements and recommendations.. 6 27 4.4 Work products.... 28 5 Project level softwareupdaterequirements... 29 5.1 Objectives... 30 31 5.3Requirementsandrecommendations.. 9 32 5.4 Work products... .10 33 6 Infrastructure design and development... 10 34 6.1 Objectives.. .10 35 6. General... 36 6.3Requirementsandrecommendations... 11 37 6.4 Work products. 38 Vehicle and vehicle systems design and development... 12 39 7.1 Objectives.. 40 7.2 General.... 41 7.3 Requirements and recommendations... 42 7.4 Work products.... .15 43 8 Software updatepackage development... 44 8.1 Objectives.. .16 45 8.2 General... 46 8..3 Requirements and recommendations.... 47 8.4 Work products .... .18 48 9 Software update campaign operations .... 49 9.1 objectives.. 18 50 9.2 General.. .18 51 .3 Requirements and recommendations..... 52 9.4 Work products... 23 53 54 55 IS0 2022 - All rights reserved ii IS0/DIS24089:2022(E) 56 Foreword 57 Iso (the International Organization for Standardization) is a worldwide federation of national standards 58 bodies (IsO member bodies). The work of preparing International Standards is normally carried out through 59 IsOtechnicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen 60 61 non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the 62 International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. 63 The procedures used to develop this document and those intended for itsfurthermaintenance are described 64 intheIso/lECDirectives,Part1.Inparticular,thedifferentapprovalcriterianeededforthedifferenttypesof 65 ISO documents should be noted. This document was drafted in accordance with the editorial rules of the 66 ISo/IEC Directives, Part 2 (see www.iso.org/directives). 67 Attention isdrawn to thepossibility that some of the elements ofthisdocumentmaybethe subject of patent 68 rights.IsO shall notbeheld responsible foridentifying any or all suchpatentrights.Detail